Product Description

Type A Heating and Insulating Riser

Product Overview

Type A heating and insulating risers are produced by shaping high-efficiency heating powder using a core-throwing machine followed by post-curing. They feature low density (approximately 0.65 g/cm³), precise dimensions, and can be either embedded directly into the mold plate during molding or inserted into the sand mold after molding. These risers are suitable for shrinkage compensation in a wide range of small to medium-sized cast iron and cast steel parts, with a modulus range of 0.7 to 3.73 cm.

The riser material has a low specific heat and a low tendency to undergo rapid cooling; once the exothermic reaction is initiated, it can provide continuous and effective heating of the molten metal within the riser. After the exothermic phase concludes, the combustion residue exhibits excellent thermal insulation properties. Compared with conventional sand risers, exothermic insulated risers delay solidification by a factor of 2.55 to 2.9 and reduce the amount of molten metal required for the riser by 50% to 70%, thereby improving process yield.

The riser exhibits high dimensional accuracy, and the William cone at the top further enhances its feeding performance.

 

Common Models

How to Use

●The riser in simplified form is designed with a slight draft, which facilitates its insertion into the preformed cavities of the sand mold. Moreover, its tight dimensional tolerances and smooth surface finish further enhance the ease and snugness of insertion.

● When using the embedment method, if the riser is inconvenient to place directly on the mold plate during pattern making, it can be embedded into the sand mold after parting.

● When the inlay method is used, the riser is placed on a pattern plate at the designated location prior to molding, allowing for both manual and machine molding in the subsequent stages. The riser possesses sufficient strength to withstand compressive and impact stresses.

Packaging and Storage

● Uses paper trays with heat-shrink film and six-sided sealing.

● Risers shall be stored in a cool, dry place, away from open flames.

● Do not remove the heat-shrink packaging until just before use to prevent moisture absorption.

Precautions

● Do not directly heat with an open flame or apply alcohol-based coatings to the vent.

●When abnormality is detected in the crystal phase at the root of the riser, it is recommended that the casting be provided with machining allowance or equipped with easy-to-cut-out sections.

●Comply with all provisions in the Safety Data Sheet (SDS) Regulation.

Keywords:

Type A Heating and Insulating Riser

Application Cases

A型发热及保温冒口在铁路件上的应用.png
A型发热及保温冒口在铁路件上的应用3.png
A型发热及保温冒口在铁路件上的应用.png
A型发热及保温冒口在铁路件上的应用3.png

Application of Type A Heating and Insulating Riser in Railway Components

A型发热及保温冒口在汽车配件的应用.png
A型发热及保温冒口在汽车配件的应用2.png
A型发热及保温冒口在汽车配件的应用.png
A型发热及保温冒口在汽车配件的应用2.png

Application of Type A Heating and Insulating Riser in Automotive Components

Online Inquiry

If you have any suggestions, please leave us a message or send an email, and we will respond to you within one business day of receiving your email.

Submit